The Spec Of Testers Manufacturer : KWT-300 serials are leak testers, it is designed for empty plastic bottles leakage testing. Machine main construction is made by stainless steel and aluminum alloy.Mitsubishi PLC control system.Easy setup and maintenance.Precise and reliable leak circuitry.The machine is including conveyor and rejection station.Cap....
The Spec Of Testers Manufacturer : There are three detectors to detect tire left side wall, right side wall and tread position. The detector is actuated by air cylinder to detect tire run-out condition while tire running. This detect singal will be input into computer to be analyzed by software and displayed on monitor in order to judge the tire wobblin....
The Spec Of Testers Manufacturer : * AC and DC voltage test by 7 stages LED displays
* Voltage reading at 12, 24, 50, 120, 230, 400, and 690
* Rx LED for continuity test indication
* Polarity indication
* Single pole phase test
* Phase rotation test with R/L LEDs displayed
* High voltage indication
* Two way clip for adjustable spacing of ....
The Spec Of Testers Manufacturer : •Designed and manufactured in accordance with ASTM D623 & ISO 4666 standards.
•By means of applying constant load and compression frequency to the test specimen, our flexometer could help user to understand the history of Heat Built-up and dynamic fatigue properties of rubber compounds. For example, while tes....
The Spec Of Testers Manufacturer : 1. Semiconductor alcohol sensor.
2. Detection range: 0.00~0.19% BAC.
3. Quick response and resume.
4. LED torch. 1. Warm-up time: within 10 sec. 2. Respond time: within 5 sec. 3. Operating temperature range: 5~40°C. 4. Power input: 3V (2xAAA battery, not included). 5. Unit size: 73x39x20 mm. 6. Print size: 1....
The Spec Of Testers Manufacturer : THIS TESTER IS DESIGNED SPECIALLY FOR TENSILE STRENGTH, ELONGATION, TEARING, STICKING,STRESS-STRAIN, PEELING, SHEARING AND ETC. FUNCTIONS OF YIELD POINT, ELASTICITY MODULUS, YOUNG’S MODULUS, GRINDINGMODULUS, PUNCTURE AND OTHERS ARE ALSO AVAILABLE. CAPACITY: 1000KGSPEED: 1~500 MM/MIN (BOTH AUTOMATIC AND MANUAL ADJ....
The Spec Of Testers Manufacturer : JIS L1095, CNS 1444/1479
1. This tester uses motor to drive and twist, to test the "Twisted level" and "Twisted Shrinkage" of "Single Fiber" or "Twisted Fiber".
2. It is suit for both "Single and Dual Fiber", "Twisted Fiber".
The Spec Of Testers Manufacturer : The armature put on the tooling. Then, start to testing. The belt will press down to rotating the limanation. The probe will hold the armature to start the testing until completion. Operate the auto test according to the following procedure: Surge Test →Insulation Resistance Test →AC Puncture Test →DCΩ Test → ....
The Spec Of Testers Manufacturer : 1. Mainly used to test pressure and resistance of shrinked linear tube.
2. Test pressure and resistance automatically, select reject automatically.
3. PLC automatic controlled, easy to operate, no operator is required. 1. Power supply: single phase 220V 50Hz 500W. 2. Air supply: 5 ~ 7 kg/cm2. 3. Efficiency: 5000 ....
The Spec Of Testers Manufacturer : SY-T105 Oil seal gyration durable life testing machine:
1. Application: suitable for various oil seals gyration durable life testing.
2. Features:
(1) Gyrate at high speed or low speed with multi-speed auto control.
(2) Test the gyration of speed, direction, temperature, time, and preset on proface scope. Test f....
The Spec Of Testers Manufacturer : 1. We designed tester all following IPC 2.3.17 (4.1) test method requirement.
2. The temperature tolerance is ± 1.5oC on a heating platen tested at 9 points.
3. The heating platen is precision machined and ground for high parallelism and flatness accuracy up to ± 0.02mm.
4. Upper, lower heating platen with PID dev....
The Spec Of Testers Manufacturer : Dustproof test machine is used to test the dustproof and dustresistant function of automobile parts. The main test includes float dust (F) and current dust (C) test and the parts to be tested include lights, panel board, taking back device of safety belt, seat adjuster, dust cover of electrical parts, steering system, ....
The Spec Of Testers Manufacturer : TM-6002 is an ideal tester for automotive, UPS maintenance and telecommunication applications.
- Quick response time.
- Simultaneously display the results of battery Impedance,voltage measurements.
- Built-in comparator function to rate the conditions as pass,warning or fail. Battery capacity : 0 to 500A ....
The Spec Of Testers Manufacturer : VC600 is a tester designed to test the clamping voltage of TVS device. Max peak power is 1500W. Test wave form is 10 x 1000uS pulse or square wave plus (1mS max). Both unipolar and bipolar TVS device can be tested. 1. Large 40 char x 16 line LCD display.
2. Real contact resistance value test.
3. Test items includ....
The Spec Of Testers Manufacturer : 1. 5 ports gigabit Ethernet switch tester.
2. NuStreams-5G is a five-port Gigabit switch tester dedicated to test switches. Not merely a stand-alone Gigabit switch tester, NuStreams-5G can also be connected to PC for accessing its simple and easy-to-use configuration utility.
3. NuStreams-5G provides 3 RUNs; each con....
The Spec Of Testers Manufacturer : The machine is made to test the inside of steel tube/pipe pressure. It is using water to inspect whether the steel has been welded properly or not or can be figure out the steel is flawed or not and also what will be the maximum pressure that can sustain for the stainless steel tube/pipe to reach consumer requirement. ....
The Spec Of Testers Manufacturer : SMAC unique electric actuator configuration such as mini inline XYZ gauging systems gives you the capability of 100% parts inspection (eliminating bad parts) and correction through immediate feedback and adjustment i the manufacturing process. Volumes up to 100 cubic mm can be covered by a single system.
The actuat....
The Spec Of Testers Manufacturer : 1. Dial diameter: 2-1/2".
2. Pressure range: 0~300psi / 21kg / cm2.
3. Housing: black-painted steel.
4. Ring: chrome-painted steel.
5. Lens: acrylic.
6. Pointer: flat black-painted aluminum.
7. Rubber protector.
8. Stem with release valve and quick release chuck for attaching fittings. 1. Spec for ada....
The Spec Of Testers Manufacturer : 1. L1, L2, two-step measurement.
2. Position presetting for L1, L2, insures fast operation.
3. Spring rate calculation.
4. Imperial or metric units switchable.
5. Length compensation built-in.
6. Printer included.
7. Load comparator available for tolerance check (optional). 1. Max load: 5 kg(500 n). 2. Min ....
The Spec Of Testers Manufacturer : ·3.5-inch TFT LCD monitor for CCTV service and testing kits.
·Diagonal screen size: 3.5-inch (diagonal)
·Color system: NTSC/PAL automatic switching
·Resolution: horizontal 480 x vertical 234 pixels
·Video input: 2 video input/1Vp-p 75Ω
·Ambient temperature: -10 to +50℃
·Power supply: 12 to 14V DC/300mA ....
The Spec Of Testers Manufacturer : 1. Functions include OPEN/SHORT test, MIS-WIRE test, CONTINUHY test, ISOLATION test, INTERMITIENT OPEN/SHORT test.
2. Self-learn from a known-good harness or cable.
3. Off-line programming (PC Link software optional).
4. System self-diagnostic and auto-scan test.
5. Check-sum analysis.
6. Bare-end cable and harnes....
The Spec Of Testers Manufacturer : 1. The vertical board is easy to move up and down.
2. For checking and correcting away from the plate. 1. Model: YC-TCS110. 2. Useful area: 900 x 1130 mm. 3. Ref．useful area (L x W): 1150 x 900 mm. 4. Tran．useful area (L x W): 1050 x 510 mm. 5. Ref light source: 36W x 1PC. 6. Tran light source: 36W x 2. 7. Dim....
The Spec Of Testers Manufacturer : *Phase Rotation Test.
*Continuity Test.
*Illumination for testing point.
*Probe cap to protect user and test probe. With GS and CE ApprovalVoltage range: 6~1000V DC, 24~1000V ACHigh Voltage Indication range: 100V~1000V AC/DCBattery (Not included): 3V (AAA 1.5Vx2) ....
The Spec Of Testers Manufacturer : This machine is designed for plastic bottles / containers leak testing. Specially for bottle makers, soft drinks, motor oil, lubricants, detergent and chemical industries to ensure bottle quality before liquid filling.
The Spec Of Testers Manufacturer : - Detects opens, shorts, miswires and split pairs on the twisted pair cabling on the LAN cable.
- Measures length.
- Auto backlit.
- Auto power off.
The backlit LCD screen displays graph wire-map, opens, shorts, miswires, split pairs and the remote ID number all on one screen. Using multiple remote ID up to 8 l....
The Spec Of Testers Manufacturer : - Phase sequence testing. Three phase motor installation and maintenance.
- Check motors for rotation direction.
- Identifies the phase sequence of three phase electrical systems.
- Indicates normal or reversed phases as well as loss of phase. Display by LED indicators.Inter-phase voltage: 45V AC up to 600V AC.S....
The Spec Of Testers Manufacturer : • Detect the phase sequence (R-S-T) of 3-phase circuit
• Electronic circuit configuration allows more specific function display
• Automated detection for low-battery capacity
Phase rotation indication by both audio and indicator, checking if currents of three different rating are in proper phase. Phase open-....
The Spec Of Testers Manufacturer : * Application:
Suitable for the tensile test of oil seal lip.
* Features:
1.By the DIN3761PT9 Standard.
2.The tensile test machine assists the design and manufacture oil seals to increase the durable life of oil seals.
3.Equip with computer software to print and record test reporter.
The Spec Of Testers Manufacturer : 1. Designed and manufactured in accordance with ASTM D623 & ISO 4666 standards.
2. By means of applying constant load and compression frequency to the test specimen, this instrument could help the user to understand the history of heat built-up and dynamic fatigue poeperties of rubber compounds. For example, whil....
The Spec Of Testers Manufacturer : 1. Testing instrument.
2. NBS. 1. The physical property tests.2. Rubber abrasion. ....
